Oatey® FlowGuard Gold® 1-Step Fast Set Yellow Cement is recommended for recommended for cold water systems and hot water systems up to 200°F / 93°C. It can be used on copper tube sizes (CTS) CPVC hot and cold potable water pipes and fittings up to 2 in. diameter with interference fit. Oatey products have earned the trust of plumbing professionals for over 100 years.
- Recommended for cold water systems and hot water systems up to 200°F / 93°C
- Approved for use with FlowGuard Gold® piping systems (Registered tradmark of Lubrizol Corporation)
- Recommended application temperature 40°F to 110°F / 4°C to 43°C
- All Oatey solvent cement and primer products are certified to UL Greenguard Gold
- Lo VOC Solvent Cement that meets California South Coast Air Quality Management District (SCAQMD) 1168/316A or BAAQMD Method 40 and various environmental requirements
- Meets ASTM Standard F493
- Complies with NSF/ANSI 61 health effects requirements
- Please refer to the Oatey Limited Warranty for warranty details
|Maximum Application Temperature °F:||110|
|Maximum Application Temperature °C:||43|
|Set Speed:||Fast Set|
|Product Type:||CPVC Cement|
|Set Type:||Standard (40 - 105° F)|
|Maximum Use Temperature °F:||200|
Available in 5 Variations
Showing 5 of 5
There are no results available
Cure times vary depending on a wide variety of factors. Please review the documents below and read our blog for more helpful information. Solvent Cement Cure Charts Solvent Cement Instructions
What PVC cements allow for the longest set-up time, for multiple joint assemblies?
The regular body cement has the longest working time once the joint has been assembled on pipe sizes up to 4” diameter. However, the regular body cement has the quickest set up time before the joint is assembled because of the quick evaporation process. Any pipe sizes over 4” should be discussed with the technical department.
What cements allow for the shortest set-up time, for multiple joint assemblies?
The heavy duty cement has the shortest working time once the joint has been assembled on pipe sizes up to 4” diameter. However, the heavy duty cement has the slowest set up time before the joint is assembled because of the slow evaporation process. Any pipe sizes over 4” should be discussed with the technical department.