Oatey® Fast Set Heavy Duty Gray PVC Cement is a medium-setting cement formulated for use on all schedules and classes of PVC pipe and fittings with interference fit up to 18-in. diameter for non-pressure and 12-in. diameter for pressure pipes. Oatey products have earned the trust of plumbing professionals for over 100 years.
- Lo-V.O.C. Solvent Cement meets California South Coast Air Quality Management District (SCAQMD) 1168/316A or BAAQMD Method 40 and various environmental requirements
- Formulated for quick installation of irrigation pipe and fittings
- Builds up for large diameter installations
- Fills gaps in large diameter pipe and loose fitting joints
- Recommended for potable water, pressure pipe, conduit and DWV
- Recommended application temperature 40°F to 110°F / 4°C to 43°C
- Meets ASTM D2564
|Maximum Application Temperature °F:||110|
|Maximum Application Temperature °C:||43|
|Set Speed:||Fast Set|
|Product Type:||PVC Cement|
|Set Type:||Standard (40 - 105° F)|
|Maximum Use Temperature °F:||140|
Available in 3 Variations
Showing 3 of 3
There are no results available
Cure times vary depending on a wide variety of factors. Please review the documents below and read our blog for more helpful information. Solvent Cement Cure Charts Solvent Cement Instructions
What PVC cements allow for the longest set-up time, for multiple joint assemblies?
The regular body cement has the longest working time once the joint has been assembled on pipe sizes up to 4” diameter. However, the regular body cement has the quickest set up time before the joint is assembled because of the quick evaporation process. Any pipe sizes over 4” should be discussed with the technical department.
What cements allow for the shortest set-up time, for multiple joint assemblies?
The heavy duty cement has the shortest working time once the joint has been assembled on pipe sizes up to 4” diameter. However, the heavy duty cement has the slowest set up time before the joint is assembled because of the slow evaporation process. Any pipe sizes over 4” should be discussed with the technical department.